Description
We have seen many different versions of these Union Jack decal over the year and this is the first one that we feel in good enough to sell. This Union Jack is made exactly as original and applied just like the original. Cross Ref.# 601-350
To apply correctly this method works well. You will need: tape, tape measure, squeegee or old credit card. (A spray bottle with Windex or mildly soapy water is optional.) 1. Take measurements from you old decal to insure you apply it in the correct area. 2. Clean the area throughly, remove all car wax and the old decal 3. Without removing the backing paper, position the decal where you want it and place a continuous piece of masking tape along the top edge of the decal to hold it in place. Double check to be sure it's lined up the way you want it. 4. Lift up the decal (or one segment of the decal), being careful not to undo the tape at the top, and starting from the top peel about half the backing paper away from the transfer paper and vinyl letter. Use the squeegee to lay it flat against the car working slowly and carefully from the top to the bottom removing the rest of the backing paper as you go. Use extra care as you lay the letter over any creases to be sure the decal doesn't gap over the crease. 5. Once all the segments have been applied you can remove all the tape and transfer paper. Optional, some customer like to have a little wiggle room and apply a very very small amount of Windex or soapy water to the area. This can give you a second chance on moving the decal but you will need to move quickly because this can soak the other transfer paper.
